30-Day Returns • Fast Dispatch • Free UPS Shipping

Categories
Chip Tuning Basics

How to Add Horsepower to Your Car: 9 Ways Compared

Nine ways to add horsepower, from a tune and intake to a turbo, compared by cost, effort and whether you can undo them. Where to start on a stock daily driver.

There are two ways to increase horsepower in a car: get more air and fuel into the engine and burn it well, or let the engine use the margin the factory left. Every method below does one or both. They differ in cost, effort, and whether you can take them back off.

1. Restore what you’ve lost (maintenance)

An engine with a clogged air filter, worn spark plugs or old oil can be down on power compared to new. Fixing that isn’t a gain over stock, but it’s the cheapest power there is — and every other upgrade assumes a healthy engine.

2. ECU tune (stage 1)

A tune changes the engine calibration: fuel, ignition timing, and on turbo engines boost. No parts. On turbo engines it’s usually the largest gain for the money, because the calibration can raise boost. On a naturally aspirated engine the gain is smaller. What is a stage 1 tune? →

It can be a flash (the ECU’s software is rewritten) or a plug-in tuner (the ECU is left as is and the car returns to stock when unplugged). Flash vs plug-in compared →

3. Cold air intake

A less restrictive intake can help the engine breathe. On many stock engines the gain on its own is small; it matters more as part of a stage 2 setup with a tune written for it.

4. Exhaust

A cat-back exhaust changes sound and flow. On turbo engines, a downpipe usually frees up more — but many downpipes replace or remove the catalytic converter.

5. Turbocharger or supercharger

Forcing more air into the engine is how big power is made. It’s also the most expensive and involved upgrade: the kit, fuel system, cooling, a tune written for it, and often a shop install.

6. Camshaft and cylinder heads

A cam with more lift and duration, or ported heads, lets the engine breathe at higher rpm. It takes engine work and a tune, and can change idle quality and low-end drivability.

7. Fuel system upgrades

Bigger injectors and a higher-flow pump don’t add power on their own. They’re what lets the engine run more boost or a bigger turbo without running lean.

8. Nitrous oxide

Nitrous adds a lot of power for a short time and is cheap to install compared to a turbo. It’s for the track: it puts heavy load on the engine and needs refills.

9. Lose weight

Not more horsepower, but the same effect on acceleration: less weight for every horsepower to move. Lighter wheels, removing what you don’t use, and lighter seats on track cars.

At a glance

Method Cost Effort Needs a tune Easy to undo
Maintenance Low Low No —
ECU tune (stage 1) Low–medium Low (plug-in) to medium (flash) It is the tune Plug-in: yes
Cold air intake Low–medium Low Helps Yes
Exhaust / downpipe Medium Medium Downpipe: yes Medium
Turbo / supercharger High High Yes No
Cam / heads High High Yes No
Fuel system Medium Medium Yes Medium
Nitrous Medium Medium Usually Yes
Lose weight Low–high Varies No Yes

Where to start on a stock daily driver

  1. Make sure the engine is healthy: maintenance first.
  2. A stage 1 tune: the gain without parts, especially on turbo engines.
  3. Only then hardware — intake, exhaust, downpipe — with a stage 2 tune written for it. What is a stage 2 tune? →

How much does a tune add?

On our dyno tests, before and after Monte:

  • Ford F-150 Raptor 3.5 EcoBoost — +21 hp, +31 lb-ft (lab test, SEMA Garage, Diamond Bar, CA)
  • Mercedes C300 2.0 turbo — +25.1 hp, +72.2 lb-ft (dyno on video)
  • Nissan 370Z 3.7 V6 — +22.3 hp, +16.8 lb-ft (Dynocom customer dyno report)
  • Mazda MX-5 2.0 — +16.6 hp, +17.1 lb-ft (Dynocom customer dyno report)

Monte is a plug-in stage 1 tuner: up to 20% more power on turbo engines, up to 12% on naturally aspirated ones. It installs in about 5 minutes, needs about 120 miles of normal driving to adapt, and unplugs back to stock. Check your car → · How to read a dyno result →

FAQ

What’s the cheapest way to get more horsepower? Fix maintenance first, then a stage 1 tune — no parts, and the largest gain for the money on turbo engines.

How do I add horsepower to a 4-cylinder car? A turbo 4-cylinder responds well to a tune because boost can be raised. On a naturally aspirated 4-cylinder, gains from a tune, intake and exhaust are smaller; big gains need forced induction.

Can I add horsepower without a turbo? Yes, but less: a tune, intake and exhaust, cam and heads. Forced induction is where large gains come from.

Does a cold air intake add horsepower? On many stock engines, only a little on its own. It helps more together with a tune written for it.

What adds the most horsepower? A turbocharger or supercharger with a supporting fuel system and tune — and it’s also the most expensive and least reversible.